USB C CAN Bus Adapter Module

Supplied with Candlelight FW Installed.

You can install slcan fw (see below)

Based on STM32F072

Type-C USB socket

Supports CAN2.0A and B, baud rates up to 1M

Compatible with cangaroo software (tested with linux) / CANable

Support with Canable / CandleLight / Klipper firmware

3-pin screw terminal: CANH, CANL, GND

Jumper (b0) to enter bootloader for firmware updates

Onboard 120R termination default or Jumper to enable/disable termination

FYSETC UCAN is a small low-cost open source USB to CAN adapter, compatible with CANable hardware.

With supplied Candlelight firmware, UCAN is enumerated as the native CAN interface on Linux.

Using alternative slcan fw, UCAN enumerates as a virtual serial port on Linux

  and acts as a serial-line for the CAN bus interface.

The UCAN adapter is compatible with ARM-based embedded platforms such as

Raspberry Pi, Raspberry Pi Zero, ODROID, BeagleBone, etc.

At the same time, it can also be used as USB to CAN application on Klipper.

Compatible with Open Source canable project 1.0 devices / firmware

More info here:

https://www.fysetc.com/products/fysetc-ucan-board

https://github.com/normaldotcom/candleLight_fw

https://github.com/HubertD/candleLight

https://canable.io

https://github.com/FYSETC/UCAN

https://wiki.fysetc.com/docs/UCAN

Choose firmware and install here:

https://canable.io/updater/canable1.html

(connect boot jumper b0 to 3v3 whilst powering up)

Product list:

1x USB to CAN module